USE THE FOLLOWING INFORMATION TO AVOID PROBLEMS WITH HOSES:
• Do not kink or tightly bend hoses. This will damage the wire braid. The minimum bend radius is approximately 12 cm [4.5 inches]. This means there should be no less than 24 cm [9 inches] between the straight sections.
• The most sensitive part of the hose is at the fitting. To reduce damage, do not bend the hose at the fitting. Keep the strain relief (spring or boot) guard over the fitting. It will help to support the hose.
• Make the layout of the hoses such that there is no risk of damage, due to vehicles, trucks etc. Do not drop objects onto hose.
• Hoses are not designed to be used as a tow rope for your pump. Do not pull on the hose to move the pump.
• Never pressurize a hose which has a kink or sharp bend.
• Hydraulic pressure in a hose, cylinder or other component can increase due to heat. Never try to push check balls or pins in couplers to reduce the pressure. To avoid such problems, always store components in warm areas.
Always discard damaged hoses to eliminate the risk of someone else using the hose. The next user might not notice the damage until the hose is pressurized. A leak in a hose can cause high pressure oil to penetrate your skin. IF YOU ARE EVER INJURED BY A SPRAY OF OIL, SEE A DOCTOR IMMEDIATELY.